TGB Hornet 50, Руководство по обслуживанию

Страница: 58 / 86

58
4-3-3 Assembly of Engine:
1.Assembly of Crank Case
A. Assemble the front Bush (1) of crank case
with a vice.
◎
The knurled side of Bush should face
inwards when installing the buffer into
the LH and RH crank cases.
◎
Extrude 1.5mm to both sides when
installing the Bush into the lug of
crank case.
B. Assemble the Bush (2) of rear shock
absorber of left crank case with sleeve
and vice.
◎
Extrude
3.0mm
to both sides when
installing the bush into the rear lug
of crank case.
◎
The size of Spacer pressed into the
Bush should be a little less the
exterior diameter of outer ring of Bush.
The Spacer must be pressed onto the
outer ring, not the inner ring.
C. Apply a thin layer of grease GA50400005
onto the lip of oil seal of the right hand
crank case and install the oil seal (3)
with special tool.
Special Tool: GA5000051F30
◎
Slanting of oil seal and damage to the
lip when press fitted shall not be
allowed.
D. Add about 0.3cc of engine oil (JASO FC)
(GA50400002) into the bearing(4) of right
hand crank shaft and press the bearing
into the right hand crank case with
special tool.
Special Tool: GA5000051F16