4. IF REPLACING THE FUSE, PLEASE ALWAYS USE A 4A TYPE.
9
BATTERY REPLACEMENT
1. PLEASE USE A SUITABLE CHARGER, MAX OUTPUT:0.4~lA. TOO MANY AMPERES WILL DAMAGE THE BATTERY.
WE SUGGEST TO ASK THE DEALER TO DO THE BATTERY CHARGING.
2. WHEN CONNECTING THE BATTERY, PLEASE CONNECT THE RED WIRE WITH THE MARK (+) AND THE BLACK
WIRE WITH THE MARK (-) OF THE BATTERY, PLEASE NOTE, CONNECT RED WIRE (+) FIRST, THEN THE BLACK
WIRE (-).
3. INSTRUCTIONS FOR REPLACING THE OLD BATTERY WITH A NEW ONE:
WARNING:
( 1 ) PLAESE USE THE SAME TYPE OF BATTERY (4AH)
( 2 ) PLEASE READ THE INSTRUCTIONS CAREFULLY(ATTACHED WITH NEW BATTERY) FOR HANDLING
BATTERIES AND THE ELECTROLYTE.
( 3 ) THE BATTERY RELEASES EXPLOSIVE GASES, PROHIBIT TO CLOSE TO SPARKS, FLAMES OR
CIGARETTES.
( 4 ) WHEN CHARGING OR USING THE BATTERY IN A CLOSED LOCATION, MAKE SURE THAT THE
VENTILATION IS GOOD.
( 5 ) THE ELECTROLYTE CONTAINS SULFURIC ACID,DON'T SPILL IT ON SKIN,CLOTHES, OR EYES.
( 6 ) IF THE ELECTROLYTE SPILLS ON THE SKIN OR CLOTHS, PLEASE WASH WITH WATER AND SOAP
IMMEDIATELY.
( 7 ) IF THE ELECTROLYTE GETS INTO YOUR EYES, FLUSH THOROUGHLY WITH WATER AND CALL FOR A DOCTOR
RIGHTAWAY.
( 8 ) BEFORE THROWING AWAY THE ELECTROLYTE CONTAINER, PLEASE WASH IT UP WITH WATER OR
NEUTRALIZE THE ACID SO AS TO AVOID ANY HARMS ON OTHERS.
( 9 ) MAKE SURE THAT THE AIR VENT HOSE IS PROPERLY AT PLACE AND WITHOUT BLOCKING OR PINCHING
(10) KEEP OUT OF REACH OF CHILDREN.
(11) WHEN YOU CHANGE NEW BATTERY ( ADDING WATER TYPE ).PLEASE INSTALL PLASTICS TUBE ( AT THE
PACKAGE )TO THE AIR VENT HOLE OF BATTERY, THE OTHER END OF THE TUBE MUST BE SETTED THROUGH
INTO THE SQUARE HOLE IN THE PLASTIC HOUSING RIGHTLY TO DISCHARGE THE EROSIVE AIR OF SULFURIC
ACID TO AVOID ERODING THE BODY, THE TUBE MUST BE WITHOUT PLUGGING OR STRAIGHT BENDING TO
AVOID EXPLODING.
4. CHECK AND KEEP THE LEVEL BETWEEN THE “ UPPER LEVEL ” AND “ LOWER LEVEL ” LINE, USING
DEMINERALIZED WATER OR SPECIAL LEAD BATTERY WATER TO ADD WHEN ELECTROLYTE BELOW “ LOWER
LEVEL” LINE.
5. DISCONNECT THE CATHODE
○
OF THE BATTERY WHEN YOU DO NOT RIDE FOR A LONG TIME.
10
DASH BOARD
c
SPEEDOMETER
d
FUEL LEVEL METER
6
4
5
1
2
3
e
ODOMETER
f
HIGH BEAM LIGHT, WHEN YOU SWITCH ON THE HIGH BEAM , THE LIGHT WILL BE ON.
g
LOW BEAM LIGHT OIL WARNING LIGHT (RED)
TURN THE MAIN SWITCH TO THE “
﹡
” POSITION BETWEEN “ ON ” AND “ OFF ” ,THE OIL WARNING
LIGHT WILL ILLUMINATE AT ONCE, THEN STOPS. A DIFFERENT APPROACH MAY CAUSE
ABNORMAL REACTIONS, PLEASE TAKE THE VEHICLE TO THE DEALER FOR DETAILED
EXAMINATION. (NORMAL VOLUME OF THE OIL TANK ABOUT 1000C.C. WHEN THE LEVEL IS WITHIN
250C.C. THIS LIGHT WILL BE ON AND PLEASE ADD THE OIL AS SOON AS POSSIBLE, OTHERWISE
THE ENGINE WILL DAMAGE)
h
TURN SIGNAL LIGHT (YELLOW)
