CCTV Tester User’s Manual
7
3
，
，
，
，
Operation Introduction
3.1 Power and battery
A. The power slide switch is located at the side of the tester. Turn the power slide switch
on to power on the tester, turn it off to power off the tester;
B. After the tester turning to sleeping mode, turn the slide switch on again to restart it;
C. This tester has panel battery inside the device, more capacity, longer working time;
D. Without the authorization from the manufacturer, please don’t release the rear panel
and try to repair the battery;
E. The batteries should be plugged in over 5 hours for full charge, when charged the
Charge Indicating LED will on, after full charging, the Charge Indicating LED light
will off and the charging work can stop automatically.
F. The charged batteries can operate for 10 hours or more.
G. When the battery indicator in system information menu shows 25 (the status number
includes 100, 90, 75, 50, 25, 5), please recharge it for use.
H. The tester can be used when it is being charged.
3.2 Main menu introduction
Turn on the device; you will see the main menu, as the following shows:
1-5 are five independent sub-menu;
Press the corresponding number button to get into the sub-menu;
Version number and S/N cant be edited;
1 SYSTEM SETUP
——>
System information
2 PTZ CONTROLLING
——>
PTZ controlling function
3 UTP TESTING
——>
UTP testing function
4 VIDEO GENERATING
——>
Video generating function
5 RS485 DATA ANALYZING
——>
RS485 protocol analyzing
6 MULTI METER
VER:V1.09 S/N:08110910
——>
Software version and S/N
3.3 Video test
