5. Presetting
WARNING!
Remove PoE jumpers for the port to which a computer will be
connected.
5.1. Resetting the switch to factory settings
Before start, set the switch to the default settings. To do this, press and
hold the DEFAULT button until the DEFAULT indicator lights up. The
default IP address of the switch is 192.168.0.1.
5.2. IP address setting
All software functions of the switch can be managed, configured and
monitored using the built-in Web interface and Telnet. Below is the
description of WEB-based configuration. Configuration via Telnet is
described in a separate document.
The switch can be managed from remote stations at any point of the
network via a standard Web browser (for example, Microsoft Internet
Explorer). The browser is a universal access tool and can directly access
the switch using the HTTP protocol.
Connect any switch port to an Ethernet network. Keep in mind,
if the device is configured over a network, the IP address of the
management work station should belong to the same IP network. For
example, if the default IP address of the switch is 192.168.0.1, then the IP
address of the work station should be 192.168.0.x (where x is the number
from 2 to 254), subnetwork mask is 255.255.255.0 by default.
Open the Web browser and enter the IP address http://192.168.0.1.
Figure 5.2. Entering the IP address of the switch
19
