13
5. Presetting
5.1. Configuring PoE on port
PoE power configuration is carried out using jumper (see section 2.3).
IMPORTANT!
All connections must be made with the disconnected power
220V.
IMPORTANT!
Remove the PoE jumpers for the port to which you will connect
the computer.
5.2. Speed mode configuration for SFP port
SFP port of the switch
can operate at the speed 100М or 1000М. To set the
speed, set the FIBER jumper according to table 5-2
IMPORTANT!
Optical SFP module with the declared speed up to 1.25 Gb
operates in 100M and 1000M modes. An optical SFP module with the declared
speed up to 155MGb operates only in 100M mode.
5.3. Enabling Preheating of camera housings
When the camera is turned on in the cold, it may not start or, even worse, fail.
To solve this problem, use the comfort start function. For this, you need to
install jumper TIMER in the position ON. After the power is turned on, the
preheating of the camera housing is switched on. Moreover, after 1 hour, when
comfortable conditions will be created in the camera housing, a video camera
will be powered. By default, this function is disabled.
IMPORTANT!
This function is available only with TFortis TH camera housings.
Table 5-2. Speed mode for SFP module
Operation mode
Location
Note
100Base-X
100M
1000Base-X
1000M
By default
