This unique feature enables to view four previously alarm set times including the current alarm 1
time. To select the desired alarm time from a previously recorded alarm time without the need to
re-enter that specific alarm time, please follow these steps:
1. Press the MEMO key to select from any previously recorded alarm times (current alarm 1
time and the 3 previous alarm times).
2. Press either the ALM1/HOUR or ALM2/MIN key to store the selected alarm time as the
current set alarm time for Alarm 1 or Alarm 2.
3. If no selection of alarm time is made, either press the SNOOZE key or the MODE key; or wait
for automatic timeout to exit the memory alarm mode.
Note:
The current alarm 1 time viewed on the memory alarm mode can also be selected and stored on
the current alarm 2 time by pressing ALM2/MIN key. Once this current alarm 2 time has set, the
current alarm 1 time will automatically replace by the previous alarm 2 time.
Upon exiting the memory alarm mode, the alarm icons (((1))) or (((2))) will be automatically ON,
indicating that the Alarm 1 or Alarm 2 is active.
BACK-LIGHT
The back-light is automatically switched ON when any keys are pressed. The back-light will be
switched on for approximately 2 seconds before automatically switching OFF. However, if any of
the keys are pressed and held down, then back-light will remain ON constantly until the key is
released.
REPLACING BATTERIES
•
For optimum running accuracy, batteries should be replaced at least once a year or when the
LCD contrast becomes dim or unclear.
•
Immediately remove all low powered batteries to avoid leakage and damage. Replace only
with new batteries of the recommended size.
Please help in the preservation of the environment and return used batteries to
an authorized depot.
MAINTENANCE
•
Avoid placing alarm clock in areas prone to vibration and shock as these may cause damage
and inaccurate readings.
•
Avoid exposure to sudden changes in temperature such as direct sunlight, extreme cold and
wet or moist conditions.
•
When cleaning the display and casing, use a soft damp cloth only. Do not use solvents or
scouring agents as they may mark the LCD and casing.
•
Do not submerge the alarm clock into water.
