38
SETTING UP:
WHEN ONE TRANSMITTER IS USED
1.
First, insert the batteries in the transmitter
(see “
How to install and replace batteries
in the temperature transmitter
”
below).
2.
Within 2 minutes of powering up the
transmitter, insert the batteries in the
Temperature Station (see “
How to install
and replace batteries in the temperature
station
”
below). Once the batteries are in
place, all segments of the LCD will light up
briefly. Following the indoor
temperature/humidity and the time as 0:00
will be displayed. If these information are
not displayed on the LCD after 60 seconds,
remove the batteries and wait for at least 60
seconds before reinserting them. Once the
indoor data is displayed user may proceed
to the next step.
3.
After the batteries are inserted, the
temperature station will start receiving data
signal from the transmitter. The outdoor
temperature data (channel 1 and 2) should
then be displayed on the Temperature
station. If this does not happen after 2
minutes, the batteries will need to be
removed from both units and reset from step
1.
4.
In order to ensure sufficient 868 MHz transmission
however, the distance between the temperature
station and the transmitter should not be more than
100 meters (see notes on “
Positioning
” and “
868
MHz Reception
”).
