Teyme ASM1-200-24, Инструкция по эксплуатации

Страница: 41 / 46

Mistblowers Notice of Instructions
Page 40 of 43
7.5. Fans
Check visually possible defects or notches, replacing the blade in case of severe defects which could cause excessive
vibrations or even breakage of all the air unit.
Counterweight the fan every time a change of this one is done or whenever an excessive vibration of the air unit is
observed.
7.6. Filters and Fittings
Check the filters every 50 working hours. Apart from being clean, check that the mesh is in perfect conditions. If not, the
effectiveness of the filter will be non-existent.
Whenever you disassemble some filter or hose you will have to be careful not to pinch the o’rings assembled on these.
When the fitting is put again in its place, spread oil and grease on the o’ring so that this fits easily its slot.
To have the filters in bad conditions, may imply plenty of non-wanted stops during the working day and lengthen
thus unnecessarily the working time.
Every time that a fitting is dissassembled to check the condition of the joint or for any other need, remember to
lubricate he closure joint with oil or grease to prevent this one from pinching itself and breaking when the fitting is placed
again in its lodging.
The lack of grease of the pump would cause that this would overheat, and all internal mobile parts could become
broken.
7.7. Nozzles
To clean or replace them you will have to help yourself with a key to unthread the bolt (D). Take out the nozzle and clean it
with air, water or with a suitable brush.
ATTENTION! Do not ever use a wire or needle because it would damage irretrievably the nozzle.
If some nozzle drips when the sectors are being closed, you will have to replace the antidrip diaphragm (E).