3
1.2 PRE-ASSEMBLY _________________________________________________________________________________
1.
Remove 1/4” hardware
(F)
and cover / counterweight
(G)
from non-motor end of reel.
2.
Block the reel with a piece of wood, and remove 3/8”
hardware
(H)
and spacer
(Z)
from the end of reel shaft.
Figure 3
Figure 4
3.
Check the reel shaft nut
(K)
to insure it is positioned
properly.
[See Figure 4]
a.
22” Groomers:
Obtain drive pulley
(J)
from bag of
parts.
a.
18” Groomers:
Obtain pulley spacer
(AD)
from bag
of parts.
b.
Slide pulley
(J)
or spacer
(AD)
onto the reel shaft.
c.
The pulley or spacer should be up against the
shoulder of the shaft with a 0.01 to 0.02 in. (.25 to .5
mm) gap between the pulley bearing and nut
(K)
.
d.
If necessary, turn nut
(K)
until proper gap is obtained.
e.
Remove pulley or spacer
and return to bag of parts.
4.
Determine how many shims will be required for driven
sub assembly
(A)
.
[See Figure 5]
a.
Obtain driven assembly
(A)
and four 0.02 in. thick
shims
(L)
from bag of parts.
b.
Slide driven assembly
(A)
onto the motor end bearing
housing and hold it squarely and tightly against the
housing.
c.
Determine how many shims
(L)
, if any, fit between
the height adjuster mounting block
(M)
and driven
assembly. Write number of shims down for assembly
purposes.
d.
Remove driven assembly
(A)
and return shims to bag
of parts.
5.
If you are installing the Turf Groomer on an LF series
mower, move the height adjust pivot
(N)
from the bottom
hole to the top hole of both driven assembly
(A)
and drive
assembly
(B)
.
[See Figure 6]
Figure 5
Figure 6
NOTE:
The bottom hole is for GKIV, GKV and G-Plex units, and
the upper hole is for Fairway units. Groomer is shipped with pivot
(N)
installed in bottom hole.
6.
If you are installing the Turf Groomer on a non-
FlashAttach™ reel with a two bolt reel motor attachment,
reposition pivot block and clamp on driven assembly as
shown in
Figure 7
. Item numbers used in the following
instructions refer to the driven assembly Illustration on
Page 14.
a.
Remove set screw from micro adjust knob
(Item 19)
and remove knob.
b.
Remove hardware
(Items 24 & 10)
holding pivot
block
(Item 11)
to driven side of groomer.
c.
Remove bolt
(Item 13)
securing rod end
(Item 12)
to
cam
(Item 23)
and remove pivot block and adjuster
assembly.
d.
Remove nut
(Item 20)
from adjusting bolt
(Item 14)
and slide bolt from pivot pin
(Item 21)
.
F
G
H
Z
AD
K
J
J
0.01
0.02
in.
AD
K
CAUTION
Pivot pin has a spring loaded detent. Be careful when
removing adjusting bolt.
A
L
M
A
B
N
Fairway Units
!
-
