Inline Battery-powered Pressing Tool
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
6
Operation
Inspect tool and jaws before use. Replace any
worn or damaged parts. A damaged or improp-
erly assembled tool can break and strike nearby
personnel.
Failure to observe this warning could result in severe
injury or death.
Electric shock hazard:
This tool is not insulated. When
using this unit on or near energized
electrical lines, use proper personal
protective equipment.
Failure to observe this warning
could result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Pinch points:
• Remove battery before changing
dies, adapters, or jaws.
• Keep hands away from the press-
ing tool head when pressing.
Failure to observe these warnings
could result in severe injury or death.
An incomplete press can cause leaks.
• Use proper fitting and tubing combinations.
Improper combinations can result in an incomplete
press.
• The relief valve will sound and the drive rollers
automatically retract when a complete press has
been achieved. If you do not hear a “pop” and the
drive rollers do not automatically retract, the press
is not complete
Failure to observe these precautions may result in
injury or property damage.
• Do not use this tool for continuous use. After 30 to
40 cycles, allow the tool to cool for 15 minutes.
• Do not secure this tool in a vise. This tool is
designed for hand-held operation.
• This tool may be used in damp or wet environ-
ments; however, air-drying is recommended before
use if the tool becomes soaked. Damage may
result when the tool is operated prior to thorough
drying when electrical components are soaked.
• Use this tool for the manufacturer’s intended
purpose only.
• Do not operate this tool without a fitting in place.
Damage to the pressing head can result.
Failure to observe these precautions may result in
injury or property damage.
Important Features of the Unit
• The hydraulic unit incorporates an automatic retrac-
tion, which returns the drive rollers to their starting
position when the maximum operating pressure is
reached.
• The unit is equipped with a special brake, which stops
the forward motion of the drive rollers when the trigger
is released.
• The pressing head can be smoothly turned by 350°
around the longitudinal axis in order to gain better
access to tight corners and other difficult working
areas.
