background image

Citation

SERVICE BULLETIN

SB680-34-27

6.

Disable any wireless connection from the laptop. The upload of the software will fail if a wireless
connection is in use.

7.

Make sure the laptop is configured with the tools CD TM7035295-012.

8.

Put the DM7038647-XXX CD into laptop's CR ROM drive.

NOTE: The software will not load properly if the DMU is used instead of the laptop.

A.

Use the FULL LOAD method to install the DM7038647-XXX Epic APM options software as
determined in the following steps.

B.

Use the Cessna online Options CD Configuration Utility. You must access to the “Customer Access”
section of CessnaSupport.com to use the utility.

Go to www.cessnasupport.com.

Click on “Customer Access”.

Log in using your Login ID and Password.

Under My Models select “Citation 680”.

Under Maintenance Information select “Epic Options Configuration Utility”.

Select the current configuration of the airplane.

OR

C.

If you do not have access to CessnaSupport.com, contact Citation Parts Distribution or Team
Sovereign directly to obtain correct Phase 5 Options CD part number to order.

CPD

Phone 1-800-835-4000 or 1-316-517-6273.

Team Sovereign

Phone 1-877-683-7344 or 1-316-517-1695

9.

Update the APM settings for WAAS, using the definition file in MM7031847-012.

A.

Put the flight software CD MM7031847-012 (or later) into the CD drive.

NOTE: The CD version must match the software version that is installed in the airplane.

B.

Start the APM settings tool on the laptop.

C.

Select the button with three dots that is to the right of the "SETTINGS.DEF" file.

D.

In the folder list that appears, navigate through the CD drive to the folder named "APM_DEFN"
and open the folder.

E.

Select the "SETTINGS.DEF" file, and select "OPEN".

F.

After the folder window closes, leaving the APM tool window, select "OPEN" again.

G.

Select "GET APM LIST".

NOTE: After a few moments, the drop down list to the left will fill with NIC's to choose from. Some

of the cockpit displays may become unusable at this time.

H.

Select "LOAD from APM".

NOTE: After a few moments, a screen will appear where the airplane options can be viewed. At

the bottom of the window, buttons labeled "NEXT PAGE" and "PREVIOUS PAGE" can be
used to flip through the available options.

I.

The settings listed below will need to be entered:

(1)

Use GPS Sensor Type CMC_C146.

J.

Use the "NEXT PAGE" button to get to the last page.

Jun 25/2010

680-34-27

Page 5

Содержание Cessna 680 Citation Sovereign













Отзывы: