SECTION 7
AIRPLANE & SYSTEMS DESCRIPTION
•
CESSNA
MODEL 172S
NOTE
. Accidental opening of a cabin door in flight due to improper
. closing does not constitute a'need to land the airplane. The
best procedure
is to set up the airplane
in a trimmed
condition at approximately
75 KIAS, momentarily shove the
door outward slightly, and forcefully close and.lock the door.
Exit from
the
airplane
is accomplished
by rotating
the
door
handle from the LOCK position, past the CLOSE position, afHo the
OPEN position and pushing the door open. To lock the airplane,
. : lock the right cabin door with the inside handle, close the left cabin
door, and using the ignition key, lock the door,
_
.>
'.
•.•
t ~
.
.
i - '.
The
left and
right
cabin
doors
are. equipped
with
openable
windows which"are held in the closed position by a detent equipped
latch on the lower edge of the window frame. To open the windows,
Irotate
the latch upward.
Each window
is' equipped with a spring-
loaded retaining' arm which will help rotate'the window outward,ahd
hold if' there.
If required, either window
may be opened
at any
speed up to 163 KIAS. The rear side windows' and rear windows are
of the fixed type and cannot be opened.
.'
.
:;
CONTROL LOCKS.
.
,;.
,).
~.
\,
A control lock is provided to lock the aileron and elevator control
surface? to prevent damage .to' these systems
by .wind buffeting
while the airplane is parked. Theldck
consists.01a
shaped steel rod
and flag. The flag identifies the control lock and cautions about its
removal before starting the engine. To install the control lock, align
the hole in the top of the pilot's control wheel shaft with the hole in
the top of the shaft collar on the instrument panel and insert the rod
into the aligned holes. Installation of the lock will secure the ailerons
in a neutraf position and the elevators
in a slightly trailing
edge
down position. Proper installation of the lock will place the flag over
the ignition switch.
In areas where high or gusty winds occur, a
control surface lock should be installed over the vertical stabilizer
and rudder. The control lock and any other type of locking device
should be removed prior to starting the engine.
.
1
7-18
May 30/00
Содержание Cessna 172S Skyhawk SP
