Textron Specialized Vehicles Cushman Shuttle 4 ELiTE 2020, Руководство пользователя

Страница: 13 / 64

S
AFETY
11
SAFETY LABELS
SAFETY LABELS
Safety and warning labels are on the vehicle for your protection. Read carefully and comply with the instructions on
the labels. If any label shown in this manual is different from the label on your vehicle, always follow the instructions on
the vehicle label.
If a label comes off or becomes illegible, contact your
dealer for a replacement. The part number is provided in this
manual, printed on the label, or can be obtained from your dealer.
Operation (P/N 662185)
Located on the dash panel.
Run/Tow Switch Operation (P/N 679115)
Located on the run/tow switch.
Operation Instructions (CE Vehicles Only) (P/N 66186)
Located on the right side of the dash.
WARNING Failure to follow these instructions can result in SERIOUS INJURY or DEATH
662185
The vehicle is not a toy; always drive responsibly. Driver must possess valid driver’s license. Never drive on public roads except where allowed
by law. Never drive vehicle under influence of drugs or alcohol. Do not start moving until all occupants are seated and holding on. Keep entire
body inside the moving vehicle. Drive slowly in congested areas, on wet or loose terrain and when backing up. Avoid sudden stops. Drive slowly
when turning. Drive straight up and down slopes. Do not coast; use brake when going down a slope. Never leave children unattended or allow
children to play on the vehicle. Never leave key in parked vehicle. Never carry more than 2 occupants on each bench seat. Never exceed vehicle
weight capacity (see owner’s guide). Never alter vehicle to increase travel speed above factory specifications. Only authorized TSV dealers should
alter vehicle using approved parts. Alterations not approved or tested by TSV can create unsafe conditions and increase risk of accident.
DO NOT alter or tamper with this unit. Unauthorized modifications
can result in SERIOUS INJURY or damage to the vehicle and will
void the warranty.
WAIT 30 seconds after reconnecting batteries BEFORE moving the
RUN-TOW switch to the RUN position.
TOWING - Always select
‘TOW’ position before towing
679115
To disable electrical system, turn key switch to ‘OFF’ and set the
RUN-TOW switch to TOW. Disconnect the battery cables.
ALWAYS set the RUN-TOW switch to TOW/STORAGE
before disconnecting or connecting battery wires.
ELECTRICAL ARC or BATTERY EXPLOSION can
occur if the switch is NOT set to TOW/STORAGE.
RUN
TOW
STORAGE
< 14° 25%
< 14° 25%
cm
MIN 150
I
O
F
I
O
R N
I
O
662186