STEP 6 - Assemble ONLY the top 2
sections of the leg poles (C). The
top section will have a small hole.
STEP 7 - Insert the top section of
the leg poles into the bottom sock-
ets of the molded corner joints.
STEP 8 - This is what your frame
should look like at this point.
STEP 9 - Spread the shower/shel-
ter skin and locate the web loop at
the top of the skin.
STEP 10 - Hook the web loop onto
the molded roof joint.
STEP 11 - Attach the speed clips to
the frame.
STEP 12 - This is what your frame
should look at this point.
STEP 13 - Connect the last section
of the leg poles and insert the pin
and ring into the bottom of each
leg pole.
STEP 14 - Stake down all 4 sides
of the shower/shelter at the rings.
STEP 15 - This is what your
shower/shelter should look like
without the fly or other acces-
sories.
STEP 16 - Drape fly over
shower/shelter and insert the at-
tached hooks into the small holes
on the leg poles as shown above.
STEP 17 - This is what your
shower/shelter with fly should
look like.
STEP 18 - Secure your
shower/shelter combo by using
guy ropes. Insert the guy rope into
the clews and knot the end as
shown above.
STEP 19 - Tie the other end of the
guy rope onto the fly loops.
STEP 20 - Loop the guy rope
around a stake and insert into the
ground.
01082 Instructions 9-12_Layout 1 10/20/12 1:07 PM Page 2
