TEXIO FGX-2220, Инструкция по эксплуатации

Страница: 200 / 229

187
8-15-13. SOURce[1|2]:BURSt:TRIGger:MANual
Set
Description This command is used to manually trigger a burst waveform
when the source trigger is set to manual for the selected
channel. This command is the equivalent of pressing the
trigger soft-key on the front panel for manual triggering.
Syntax SOURce[1|2]:BURSt:TRIGger:MANual
Example SOUR1:BURS:TRIG:MAN
. Manually triggers the burst waveform.
8-16. Arbitrary Waveform Commands
8-16-1. Arbitrary Waveform Overview
Use the steps below to output an arbitrary waveform over the remote interface.
Output Arbitrary
Waveform
Select Waveform
Frequency,
amplitude and
offset
Load Waveform
Data
Set Waveform
Rate
1. Use the SOURce[1|2]:FUNCtion USER command to
output the arbitrary waveform currently selected in
memory.
2. Use the APPLy command to select frequency,
amplitude and DC offset. Alternatively, the FUNC,
FREQ, AMPl, and DCOffs commands can be used.
3. Waveform data (1 to 4096 points per waveform) can
be downloaded into volatile memory using the
DATA:DAC command. Binary integer or decimal
integer values in the range of ± 511 can be used.
4. The waveform rate is the product of the number of
points in the waveform and the waveform frequency.
Rate = Hz × # points
Range: Rate: 120MHz
Frequency: 60MHz
# points:
1~4096