D.
Press
to return to Vcut page.
E.
Press
，
The machine will cut two vertical lines in X
direction
，
if it cut like this:
or
,you need to adjust the knife
position manually for fine-tuning till it can cut like this
.
First loosen the screws fixing the knife in the figure above until the
knife can move, then use a wrench to turn the set screw, change the
knife position and fix the knife again.
F.
Go on debugging according to the method in D till the two lines in
the Y direction can coincide.
G.
When use the small knife V-cut tool to cut the material
，
the SP number
is
SP5
and
it
needs
to
set
，
Only
the
“
up
”
parameter,knife depth,speed parameter and extend parameter
can be changed.
7.9Punching Tool
（
SP2
）
（
Note:There are two main specifications of punching knife, a V-shaped
knife and a round knife
，
the function button in the
“
config
”
must be
when use the V-shaped knife, and it must be
when use
the round knife.
）
(1)Please install the V-knife in strict accordance with the following
sequence
，
when the A axis coordinate is 0.00,the opening side of the
v-knife must face the X + direction.
(2)Please install the V-knife in strict accordance with the following
Содержание XYZ 2518
Страница 1: ...TEXI XYZ 2518 MANUAL...
