Speech Dialler
Installation Manual
10
INS232
Commissioning
1.
Once all necessary connections have been made to the
Speech Dialler
, re-
connect the loudspeaker to the main circuit board and clip the cover on to the
base taking care not to trap any cables.
2.
Re-apply mains power to the control panel and reconnect the battery.
3.
The
Speech Dialler
will enter its initialisation mode (15 seconds), to load the
factory default parameters press the red record
'
key 5 times then the
(
key during this mode. The display will show: “
!"#$%&'()'*+,,,
-"#$.#)/$&0,,,
”. If you only want to default the passcode then press red
record
'
key 3 times then the
(
key during initialisation mode.
4.
After the unit has finished initializing/loading defaults the display will show
“
,,,,1&.$2"#1,,,,
” To select the programming mode enter the default
passcode of
!"#$
.
5.
The display will show “
345)67).898:6;<)!7=6>:6)186>?9@
” The unit is
now ready for programming and testing. Please refer to the “Operating
Instructions” for full details.
6.
After the
Speech Dialler
has been programmed and tested, secure the front
cover with screw and screw cap that is provided in the spares pack.
Specifications
Supply Voltage:
10 - 14VDC
Current Consumption:
35mA (Standby), 100mA (Active)
Trigger Inputs:
4; +ve applied or +ve removed (5 - 24VDC)
Outputs:
2; Open collector switched –ve @100mA
Telecommunications Approval:
CTR21
REN Rating:
1
Dialling Formats:
Pulse or DTMF
Dimensions:
140mm x 115mm x 30mm
Packed Weight:
360g (Approximately)
ukpanels.com
