www.texas.dk
13
READ and UNDERSTAND this manual completely before using Utility Dump Cart.
Operator must read and understand all safety and warning information, operating instructions,
maintenance and storage instructions before operating this equipment. Failure to properly operate and
maintain the utility dump cart could result in serious injury to the operator or bystanders.
Operation Warnings
Do not at any time carry passengers sit or stand on the cart.
Do not allow children to play on, stand upon or climb in the cart.
Always inspect the cart before using to assure it is in good working condition.
Replace or repair damaged or worn parts immediately.
Always check and tighten hardware and assembled parts before operation.
Do not exceed equipment maximum load capacity of 300 kgs.
Avoid large holes and ditches when transporting loads.
Be careful when operating on steep grades (hill) the cart may tip over.
ALWAYS operate at reduce speed in rough terrain, along creeks, ditches and on hillsides.
Do not operate close to creeks, ditches and public highways.
To avoid personal injury and/or equipment damage DO NOT EXCEED 8 km/h.
Always use caution when loading and uploading the cart.
Only tow with recommended vehicles (Lawn/Garden Tractors and ATVs).
Crush and Cut Hazards
Always keep hands and feet clear from moving parts while operating the equipment.
Always clear and keep work area clean when operating.
Always
wear safety gear, eye protection, gloves and work boots when operating the dump cart.
WARNING
The warnings, cautions, and instructions outlined in this instruction manual cannot cover all
possible conditions or situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product and must be
supplied by the operator.
Assembly Is Required
This product requires assembly before use. See
“Assembly” section for instructions. Because of the
weight and/or size of the utility dump cart, it is recommended that another adult be present to assist
with the assembly.
INSPECT ALL COMPONENTS
closely upon receipt to make sure no components
are missing or damaged.
General Warnings