www.texas.dk
31
13. Trouble shooting
PROBLEM POSSIBLE
CAUSE
SOLUTION
1.No spark.
Check the spark plug. Take off the spark plug,
place the spark plug cap on the spark plug and
place the spark plug on the metal cylinder. Pull
she starter and check if there are sparks on the
top of the spark plug. If there are no sparks
repeat procedure with a new spark plug. If still
no sparks contact local dealer.
2. No fuel.
Press the fuel primer. If the problem persists,
contact your local dealer.
3. “Drowned” engine.
Remove the spark plug and turn the trimmer so
that the spark plug hole faces the ground.
Switch the choke to “RUN” and pull the starter
10-15 times. Clean the spark plug and fit it
again. You may also replace the spark plug. Pull
the starter 3 times with the choke switched to
“RUN”. If the engine does not start, move the
choke to “Choke” and normal starting procedure
is used. If the engine still does not start, repeat
the procedure with a new spark plug.
The engine does not
start.
4. The starter must be pulled
harder than when the machine
was new.
Contact your local dealer.
The engine starts but
does not accelerate.
The carburetor needs
adjustment.
Contact your local dealer.
The engine starts but
can only run on full
power and on half
choke
The carburetor must be adjusted,
repaired or cleaned.
Contact your local dealer.
1. Check the mix of the fuel.
Use new fuel with the correct mix.
2. The air filter is dirty
Clean or replace.
The engine does not
run on full power and
smokes heavily.
3. The carburetor needs
adjustment.
Contact your local dealer.
The engine starts,
runs, and accelerates
but can not run idle.
The carburetor needs
adjustment.
Contact your local dealer.
1. The line is melted together.
Replace. You may be using the tool too close to
stones and walls.
2. Too little line.
Fit more line.
3. The line is worn short.
Pull out more line while alternately pressing the
line head down and letting go.
4. The line is entangled.
Remove the line from the spool and fit it again.
The line can not be
pulled forward.
5. The rotations of the engine are
too slow.
Pull out more line at full speed.
1. Tall grass is cut at base.
Cut the grass from the top and downwards.
Grass is wrapped
around the gear head
or line head .
2. The trimmer is not used at full
speed.
Use the trimmer at full speed.
The spool head is
difficult to turn.
The threads are dirty, damaged
or full of grass.
Clean the threads and grease or change the
spool head. Remove any grass..
1. The trimmer is not used on full
power.
Use full power
2. Check the mix of the fuel.
Use new fuel and correct two-stroke mix.
3. The air filter is dirty.
Clean or replace.
Oil leaks from the
exhaust
4. The carburetor needs
adjustment.
Contact your local dealer.
