Texas Instruments TUSB213, Руководство пользователя, Страница: 2 / 13

USB 3.1 Type- W o
USB 3.1 Type-
W o
USB 3.1 Type-B Receptacle
USB 3.1 Device/Sink (External Hard Drive, Thumb Drive, and so forth)
USB 3.1 Type-B Receptacle (Input)
USB 3.1 Type-A Receptacle (Output)
TUSB213 EVM
USB 3.1 Host/Source (Desktop, Laptop, Docking Station, and so forth)
USB 3.1 Type-A Receptacle
Copyright © 2017, Texas Instruments Incorporated
Introduction
www.ti.com
2 SLLU264 – August 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TUSB213 Evaluation Module
1 Introduction
The TUSB213 is a USB high-speed (HS) signal conditioner, designed to compensate for ISI signal loss in
a transmission channel.
The TUSB213 design is agnostic to USB low and full-speed signals and does not affect full-speed (FS)
and low-speed (LS) signaling. High-speed signals are compensated along with programmable DC gain to
fine-tune device performance to optimize the HS signals at the connector.
This EVM was designed to be used as a medium connection between a USB host and a USB device. The
interface to the EVM consists of a USB 3.1 Type A receptacle, and a USB 3.1 Type B receptacle.
Therefore, in order to connect the EVM to your system set up, you will most likely need 2 USB 3.1
Standard Type A
→ B cables. Your test setup should look similar to Figure 1 :
Figure 1. Functional System Level Block Diagram