Software Start-Up
11
SLWU086C – November 2013 – Revised January 2016
Copyright © 2013–2016, Texas Instruments Incorporated
TSW14J56 JESD204B High-Speed Data Capture and Pattern Generator
Card User's Guide
Figure 4. TSW14J56EVM Serial Number
Click “OK” to connect the GUI to the board. The top level GUI opens and appears as shown in
.
Figure 5. High-Speed Data Converter Pro GUI Top Level
If the message “No Board Connected” opens, double check the USB cable connections and that power
switch SW6 is in the on position. Remove the USB cable from the board then re-install. Click on the
“Instrument Option” tab at the top left of the GUI and selecting “Connect to the Board”. If this still does not
correct this issue, check the status of the host USB port.
When the software is installed and the USB cable is connected to the TSW14J56EVM and the PC, the
TSW14J56 USB 3.0 converter should be located in the Hardware Device Manager under the universal
serial bus controllers as shown in
labeled as Cypress FX3 USB StreamerExample Device. When
the USB 3.0 cable is removed, this driver will no longer be visible in the device manager. If the drivers are
present in the device manager window and the software still does not connect, remove the USB 3.0 cable
from the board then reconnect. Attempt to connect to the board. If the problem still exists, cycle power to
the board and repeat the prior steps.
