DAC and ADC GUI Configuration File Changes When Using a Xilinx Development Platform
16
SLAU580B – June 2014 – Revised September 2016
Copyright © 2014–2016, Texas Instruments Incorporated
TSW14J10 FMC-USB Interposer Card
6.1
DAC38J84EVM with Xilinx VC707 Development Board Setup Example
This section provides an example of the TSW14J10EVM being used to test the DAC38J84EVM with a
Xilinx VC707 development platform as shown in
. This example shows what must be modified in
the DAC3XJ8X GUI for a setup using 4 lanes (LMFS = 4421), 1x interpolation, and a DAC sample rate of
368.64M. Setup the hardware as follows:
Figure 7. DAC38J84EVM GUI Setup Example
1. Connect J5 of the TSW14J10 to FMC HPC connector J35 on the VC707.
2. Connect the DAC to the other end of the TSW14J10.
3. Connect the power cables to the VC707 and DAC38J84.
4. Connect a USB cable between the TSW14J10 and a host computer with the HSDC Pro GUI loaded.
5. Connect a USB cable between the DAC38J84 and a host computer with the DAC3XJ8X GUI loaded.
