FT232
MSP430
DRV2605
LRA Motor
TSC2013
Resistive
Touch Panel
I
2
C
I
2
C
USB
www.ti.com
Kit Operation
7
Kit Operation
The following section provides information on using the TSC2013EVM, including setup, program
installation, and program usage.
7.1
TSC2013EVM-PDK Block Diagram
Figure 1
shows a block diagram of the TSC2013EVM. The TSC2013 and DRV2605 device are both
controlled by an MSP430™ microcontroller (MCU) through an I
2
C interface. One resistive touch panel is
connected to the TSC2013 device by a 4-pin FPC connector and an LRA motor is attached as an
actuator. The FT232 device is a USB-to-serial UART interface and is used to transfer data from the
MSP430 MCU to the host PC or is used to receive commands from the host PC.
Figure 1. TSC2013EVM Block Diagram
3
SLVUA92 – July 2014
TSC2013EVM User's Guide
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated