10.4 Pop-Up for Some Commands While Conversion is Enabled
Some commands will cause a pop-up like the one shown in
when trying to change them while
conversion is enabled. The settings in the GUI which will cause this pop-up include
FREQUENCY_SWITCH
,
USER_DATA_01 (Compensation)
,
Vout Mode
, and
Vout Scale Loop
. To change these settings to a new value,
click on
Stop Power Conversion
then
Close and continue
. The GUI will automatically disable conversion, write
the new value, and enable conversion again.
Figure 10-4. Pop-up When Trying to Change FREQUENCY_SWITCH With Conversion Enabled
Using the Fusion GUI
26
TPSM8D6C24EVM-2V0 User's Guide
Copyright © 2021 Texas Instruments Incorporated
