Setup
4
SLVUBT6A – October 2019 – Revised May 2020
Copyright © 2019–2020, Texas Instruments Incorporated
Using the TPS8804EVM
2.4
USB2ANY Connection
Use a USB cable to connect the USB2ANY adapter to a computer with the TPS880x GUI installed. Open
the TPS880x GUI and verify the USB2ANY adapter is recognized (see
). With the EVM powered,
connect the USB2ANY adapter to the EVM using the USB2ANY adapter 10-pin ribbon cable. Click
EXPLORE TPS8804EVM
then
QUICK START
and select the device address corresponding to the J6
jumper (see
). Send the test command to verify the EVM, USB2ANY adapter, and GUI
software are all connected.
Figure 2. TPS880x GUI Connected to USB2ANY Adapter
