Texas Instruments TPS7A14EVM-058, Руководство пользователя, Страница: 6 / 17

The slew rate of the load step can be adjusted by C11, R7, R8, and R9. In this section, only R8 and R9 is
adjusted to set the slew rate. For a 0-mA to 1-A to 0-mA load step, use
Table 2-1 to select a value of R8 and R9
that results in the desired rise or fall time.
Table 2-1. Suggested Ramp Rate Resistor Values
R8 R9 Rise/Fall Time
97.6 kΩ 86.6 kΩ 10 µs
52.3 kΩ 40.2 kΩ 5 µs
31.6 kΩ 20.5 kΩ 2.5 µs
12.4 kΩ 8.06 kΩ 1 µs
6.19 kΩ 4.02 kΩ 500 ns
3.74 kΩ 2.43 kΩ 300 ns
2.49 Ω 1.62 Ω 200 ns
806 Ω 806 Ω 100 ns
After the EVM is modified (if needed), connect a power supply to banana connectors J17 (VDD) and J21 (GND)
with a 5-V DC supply and a 1-A DC current limit. As illustrated in
Figure 2-3 and Figure 2-4 , the TPS7A14
transient response is very fast and the output voltage recovers in well under 1 ms after the initial load transient.
Therefore, use a load transient pulse duration limit of 1 ms to prevent excessive heating of the pulsed resistors
(R2, R3, R4, R5, and R6). Configure a function generator for the 50-Ω output, in a 0-V DC to 5-V DC square
pulse. If necessary, burst mode can be configured in the function generator for repetitive, low duty cycle, load
transient testing.
A 10.7-kΩ resistor is installed on the EVM at R8, and a 10-kΩ resistor is installed on the EVM at R9. These
resistors provide approximately 1 A/μs slew rate from 0 mA to 1 A.
Figure 2-3 and Figure 2-4 provide example
test data with R8 = 10.7 kΩ and R9 = 10 kΩ. The red trace is the output voltage and the blue trace is the output
current. J10 provides 1 mA of DC load current and R2, R3, R4, R5, and R6 provide 949 mA of pulsed load. The
resulting test data shows a 1-mA to 950-mA load step on VOUT of the LDO, with only a 2.2-μF capacitor on the
output of the LDO.
Figure 2-3. TPS7A14EVM-058 Load Transient
Results: 1-mA to 950-mA Load Step
Figure 2-4. TPS7A14EVM-058 Load Transient
Results: 950-mA to 1-mA Load Step
Setup www.ti.com
6 TPS7A14EVM-058 Evaluation Module SBVU073 – NOVEMBER 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated