5.1.15 TP1, TP2, TP3 and TP4 – CC1 and CC2 Test Points
Test points CC1 and CC2 are used to tie a PD protocol analyzer for PD BMC data or to verify the BMC signal
integrity with an oscilloscope (depending on the cable orientation). Use a multimeter or oscilloscope to measure
VCONN when an electronically marked USB Type-C cable is connected. Use these test points to attach an
external load on VCONN.
and
the highlight these features.
Figure 5-31. TP1, TP2, TP3 and TP4 – CC1 and CC2 Test Points
Figure 5-32. TPS65988 BMC Data
Setup
22
TPS65988 Evaluation Module
SLVUB62B – JUNE 2017 – REVISED NOVEMBER 2020
Copyright © 2020 Texas Instruments Incorporated
