Firmware Installation
9.2
Wire Aardvark to SPI Pins for Flash on the TPS65982-EVM board
Wire the Aardvark SPI pins to the corresponding SPI pins on the TPS65982-EVM J2 and J3 headers as
shown in
NOTE:
Once wire connections are made, connect the Dell Power Adapter (Barrel Jack AC Adapter)
to the TPS65982-EVM to power up the board.
Figure 14. Aardvark Wired to SPI Pins
9.3
Run “Flash Center”.exe
Connect the Dell Power Adapter to the TPS65982-EVM and connect the Aardvark USB cable to your
computer. Next, boot up the Flash Center software (
) from the directory location you previously
installed it.
Figure 15. Flash Center GUI
39
SLVUAF8C – June 2015 – Revised November 2015
TPS65982 Evaluation Module
Copyright © 2015, Texas Instruments Incorporated
