Texas Instruments TPS65400, Руководство пользователя, Страница: 8 / 24

Table 4-1. Input/Output Connection
No. Function Description
J2 Buck1 Connector Output of Buck1
J5 Buck2 Connector Output of Buck2
J7 Buck3 Connector Output of Buck3
J9 Buck4 Connector Output of Buck4
J6 Buck1/2/3/4 VIN Connector Apply power supply to this connector
J13 PMBus/I
2
C Interface connector Communication via PMBus/I
2
C Interface
Table 4-2. Jumpers
No. Functions Description
JP1-PVIN34-Vin-PVIN12 Short VIN to PVIN34 Vin tied to PVIN34
JP3-PVIN12-PVIN34 Short PVIN12 with PVIN34 PVIN34 tied to PVIN12
JP10-3-4 Connect Cap to SS1 tied SS1 to C40
JP10-7-8 Connect Cap to SS2 tied SS2 to C42
JP10-11-12 Connect Cap to SS3 tied SS3 to C43
JP10-15-16 Connect Cap to SS4 tied SS4 to C44
4.2 Hardware Requirement
This EVM requires an external power supply capable of providing 4.5 V to 18 V at 6 A.
The EVM kit includes USB2ANY interface box which, when installed on a PC and connected to the EVM, permits
communication with the EVM via a GUI interface. The minimum PC requirements are:
• Microsoft ® Windows ® 2000, Windows XP, or Windows 7 operating system
• USB port
• Minimum of 30MB of free hard disk space (100MB recommended)
• Minimum of 256MB of RAM
4.3 Hardware Setup
After connecting the power supply to J6 and turning on the power supply, the EVM regulates the output voltages
to the value listed in
Table 1-1 . Additional input capacitance may be required in order to mitigate the inductive
voltage droop that may occur during a load transient event.
In order to change the output voltage by sending the digital control signal via a PC running the TPS65400
controller software and USB2ANY interface box, perform the following steps:
1. Connect the USB port of USB2ANY to the PC using the USB cable and the other end to J13 of the
TPS65400 using the supplied 30-pin ribbon cable ( Figure 4-2 ). The connectors on the ribbon cable are
keyed to prevent incorrect installation.
2. Connect the power supply on J6 and turn on the power supply.
3. Run the software as explained in
Section 4.4 .
Bench Test Setup Conditions www.ti.com
8 TPS65400 Buck Converter Evaluation Module User's Guide SLVUAC4A – OCTOBER 2014 – REVISED MAY 2021
Submit Document Feedback
Copyright © 2021 Texas Instruments Incorporated