IPG-UI Setup for TPS65291
18
SLVUB61 – July 2017
Copyright © 2017, Texas Instruments Incorporated
Software Installation and Setup Instructions
Figure 18. Creating New IPG-UI Project for the TPS65291
•
Click the
Create Project
button.
NOTE:
After a project is initially created, it is available in the
Create Projects from Recent Devices
menu. When a project is saved, it is available in the
Open Recent Projects
menu.
•
Verify that a blue notification appears stating that register write access is enabled as shown in
.
Figure 19. Successful Write Access to TPS65291 Notification
•
The TPS65291
Introduction
tab is now displayed. If a red notification appears (as in
), it
indicates the computer can talk to the USB2ANY but cannot communicate with the TPS65291 device.
The primary cause of this issue may be that the power supply is not turned on or a cable is unplugged.
In case of either issue, the test setup of the EVM must be debugged before continuing.
Figure 20. Failed GUI Communication to TPS65291 Notification
•
Click the
Get Started
button or the
Register Map
tab shown in
to begin reading from and
writing to registers to evaluate the TPS65291 device.
