x
x
x
x
x
x
x
x
PC
USB to ANY Interface
TPS65083xEVM-095
Power Supply
Load for Testing
Any VR
Ribbon
Cable
USB / miniUSB
Cable
Green LED
J1
J2
J32
Setup
4.3.1
J4 - SLP_SUS#
SLP_SUS# is active low and when set low will put the device into sleep state SUSPEND. When
SLP_SUS# asserts high, VR5 and VR1 turn on as well as the device enabling a load switch.
4.3.2
J4 - SLP_S4#
SLP_S4# is active low and when set low will put the device into sleep state 4. When SLP_4# asserts high,
VR4 turns on as well as the device enabling a load switch.
4.3.3
J4 - SLP_S3#
SLP_S3# is active low and when set low will put the device into sleep state 3. When SLP_3# asserts high,
the device enables a load switch.
4.3.4
J4 - SLP_S0#
SLP_S0# is active low and when set low will put the device into sleep state 0. When SLP_0# asserts high,
VLDO1 turns on.
5
Setup
5.1
Hardware Setup
Figure 8. Hardware Board Connection
Before connecting the EVM, always remember to preset the power supply to correct voltages. Never "hot
plug" or connect the power supply to the EVM with the power supply on. This can result in 2x input voltage
overshoot that can damage the devices on the EVM.
Connect the EVM as shown in
. Before turning on the power supply, set the SLP_Sx# jumpers to
LOW as they must be sequenced in the proper order for correct power up. The order for sequence is
SLP_SUS#
→
SLP_S4#
→
SLP_S3#
→
SLP_S0#.
Once the power supply is on and providing a valid VIN voltage, the SLP_Sx# signal can be set to HIGH in
the listed sequence. After this, the EVM will have all power rails ON and regulating to their set voltage.
ALL_SYS_PWRGD, TP71, should be HIGH signaling a valid power up of the system.
5.2
Software Setup
To install the GUI, first download the GUI from the Tools & Software folder at
http://www.ti.com/product/TPS650830/toolssoftware
. Once the zip file is open, simply double-click the
Setup TPS65083xEVM.msi file. Follow the recommended prompts for installation.
11
SLVUAD6 – December 2014
TPS650830EVM-095
Copyright © 2014, Texas Instruments Incorporated