Setup
2
SLVU950A – August 2013 – Revised February 2019
Copyright © 2013–2019, Texas Instruments Incorporated
TPS3700EVM-202 High voltage (18V) window voltage detector evaluation
module for SON package
2.1
Input/Output Connector and Jumper Descriptions
2.1.1
J1 – VDD
This connector is the power supply connection.
This also may be the signal that is being monitored by the TPS3700.
2.1.2
J2– GND
Return connector for the input power supply. This connector is also connected to J4 and J6 in the EVM.
2.1.3
J3 – SENSE
This connector is an additional voltage signal that can be monitored if VDD is not being monitored.
2.1.4
J4 – GND
Return connector for the SENSE voltage signal. This connector is also connected to J2 and J6 in the
EVM.
2.1.5
J5 – OUTA
This connector is the under-voltage open drain output of the TPS3700 that pulls up to VPU through a 100-
k
Ω
resistor in the EVM. Connect a voltage meter or oscilloscope probe from J5 to GND (J6).
2.1.6
J6 – GND
Return connector for the OUTA voltage signal. This connector is also connected to J2 and J4 in the EVM.
2.1.7
J7 – GNDOUTB
This connector is the over-voltage open drain output of the TPS3700 that pulls up to VPU through a 10-k
Ω
resistor in the EVM. Connect a voltage meter or oscilloscope probe from J7 to GND (J6).
2.1.8
JP1 – Monitor Sense and Monitor VDD Select
The TPS3700EVM-202 EVM is designed to monitor either the supply voltage VDD or an additional voltage
signal SENSE.
A shorting jumper allows the choice of monitoring VDD or SENSE.
shows the connections for
choosing between the two.
Table 1. Connector J10 Selections
Short Pins
Monitor
1 and 2
SENSE
2 and 3
VDD
2.1.9
J11 – VPU
The TPS3700EVM-202 EVM is designed for OUTA and OUTB to pull up to either VDD or an external
voltage source.
shows the connections for choosing between the two.
Table 2. Connector J11 Selections
Short Pins
Pull-Up Voltage
VPU
1 and 2
VDD
Open
External Voltage on Pin 1