Texas Instruments TPS26630-33EVM, Руководство пользователя

Страница: 10 / 24

General Configurations
www.ti.com
10 SLVUBI8A – October 2018 – Revised March 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
TPS26630-33EVM: Evaluation Module for TPS2663x
3.4.5 Output Short-Circuit Protection Test
Follow the instructions to verify the output short-circuit protection feature of the device:
1. Set up the oscilloscope as listed in Table 11 .
Table 11. TPS26630-33EVM Output Short-Circuit Protection Test
Oscilloscope Setting CH1 Probe Points CH2 Probe Points
Channel 1 = 10 V / div VIN_SYS1 (TP3) VIN_SYS2 (TP12)
Channel 2 = 10 V / div VOUT1 (TP4) VOUT (TP13)
Channel 3 = 20 V / div FLTb1 (TP1) FLTb2 (TP10)
Channel 4 = 2 A / div Input current into T1 +Ve wire Input current into T3 +Ve wire
Trigger source = Channel 1
Trigger level = 12 V ±1 V
Trigger polarity = Falling
Trigger mode = Single
Time base 5 ms / div
2. Set the current limit 2 A by installing the J4/J10 jumper in position 5-6.
3. Set the load resistance to 24- Ω ±1
Ω
and the power supply voltage to 24 V. Enable the load and the
power supply.
4. Use either wire or FET to short the output to ground and verify the output short-circuit response
waveform as shown in Figure 3 .
Figure 3. Output Short-Circuit Protection