Texas Instruments TPA6138A2 EVM, Руководство пользователя

Страница: 3 / 8

www.ti.com
Operation
2 Operation
This section describes how to operate the TPA6138A2EVM.
2.1 Quick-Start List for Stand-Alone Operation
Use the following steps when operating the TPA6138A2EVM stand alone or when connecting the EVM
into an existing circuit.
2.1.1 Power and Ground
1. Verify that the external power sources are set to OFF.
2. Set the power supply voltage between 3 V and 3.6 V. When connecting the power supply to the EVM,
first connect the ground connection to the GND connector, and then connect the positive supply to the
V
DD
connector. Verify that the connections are made to the correct banana jacks.
2.1.2 Inputs and Outputs
2.1.2.1 Audio
1. Verify that the audio source is set to the minimum level.
2. Connect the audio source to the inputs, LIN and RIN. Shunt JP1 and JP2 for single-ended input.
3. Connect a headset or other load to the headphone jack.
2.1.2.2 Shutdown Controls
1. Shutdown is controlled by pushbutton S1. Press and hold S1 to place the TPA6138A2 in shutdown.
Release S1 to reactivate the TPA6138A2.
2.1.3 Power Up
1. Verify the correct connections as described in the Power and Ground and Inputs and Outputs sections.
2. Verify the correct voltage setting of the power supply and turn ON the power supply. Proper operation
of the EVM should begin.
3. Adjust the audio signal source as needed.
3 SLOU305A – November 2010 – Revised January 2011 TPA6138A2 EVM
Submit Documentation Feedback
© 2010–2011, Texas Instruments Incorporated