Getting Started
Inputs and Outputs
1. Ensure the signal source is turned off or set to a minimum.
2. Connect the left signal source to the RCA jack labeled LIN+ (J5), and the right signal source to the
RCA jack labeled RIN+ (J6).
3. Insert headphones into 3.5 mm headphone jack (J4).
Power Up
1. Verify correct voltage polarity on the supplies.
2. Turn on the power supply.
3. Turn on the signal source.
4. Adjust signal source level as needed.
Figure 1. TPA6120A2RGY EVM Top Layer
3
SLOU394 – July 2014
TPA6120A2RGY Evaluation Module
Copyright © 2014, Texas Instruments Incorporated