Using The TPA0212 EVM With the Plug-N-Play Evaluation Platform
3-10
Details
3.3.2.1
S1 — Shutdown Switch
Pushbutton switch S1 on the EVM allows the manual shutdown of the
TPA0212 amplifier IC.
3.3.2.2
S2, S3 — Gain Select Jumpers
Jumpers S2 and S3 select the gain of the TPA0212 amplifier IC line as shown
in Table 3–2.
Table 3–2. TPA0212 EVM Gain Settings
S2
S3
OUTPUT MODE
GAIN (V/V)
OFF
OFF
BTL
2
OFF
ON
BTL
6
ON
OFF
BTL
12
ON
ON
BTL
24
X
X
SE
1
Note:
ON = Shunt installed, OFF = Open, X = Don’t care
3.3.2.3
S4 — Output Mode Jumper
To keep the module amplifier IC in the single-ended output mode regardless
of the module control input state, set jumper S4 to ON.
Jumper S4 connects the SE/BTL output mode control input pin on the amplifier
IC directly to V
DD
, so that when S4 is ON, the IC is held in the single-ended
output mode regardless of the state of the SE/BTL module control input. When
S4 is OFF, a pulldown resistor on the module holds the IC output mode control
input pin low, keeping the IC in the BTL output mode.
The TPA0212 amplifier IC has two separate inputs for each channel. An
internal multiplexor selects which input will be connected to the amplifier
based on the state of the SE/BTL pin on the IC.
3.3.2.4
S5 — Input Mode Jumper
To force the module amplifier IC to use the HP input regardless of the module
control input state, set jumper S5 to ON.
Jumper S5 connects the HP/LINE input mode control pin on the amplifier IC
directly to V
DD
, so that when S5 is ON, the IC is held in the HP input mode re-
gardless of the state of the HP/LINE module control input. When S5 is OFF,
a pulldown resistor on the module holds the IC input control mode input pin low,
allowing the IC to use the LINE inputs as the source of an input signal.
3.3.2.5
S6 — Input and Output Mode Jumper
To force the module amplifier IC to use the HP input when in SE output mode
and to use the LINE input when in BTL output mode, set jumper S6 to ON.
When jumper S6 is ON, the HP/LINE input mode control pin on the amplifier
IC and the SE/BTL output mode control pin on the amplifier IC are shorted to-
gether so that both the input and output multiplexors switch simultaneously.
When S6 is OFF, the input and output modes may be switched independently
of each other.
Содержание TPA0212
Страница 1: ...TPA0212 Audio Power Amplifier Evaluation Module March 2000 Mixed Signal Products User s Guide SLOU071...
Страница 4: ...iv...
Страница 10: ...1 4 Introduction...