TLV2553EVM-PDK Initial Setup
7
SBAU247A – June 2015 – Revised September 2019
Copyright © 2015–2019, Texas Instruments Incorporated
TLV2553EVM-PDK Evaluation Module
5.2
Connectors J3 and J4
J3 and J4 are for TI internal use only and are not installed by default. However, their pins can be used as
test points (that is, for meter hookups only).
CAUTION
Do not drive the J3 or J4 pins with external voltage sources. Doing so may
cause damage to the onboard sources.
5.3
EVM Graphical User Interface (GUI) Software Installation
The following steps describe how to install the software for the TLV2553 EVM graphical user interface
(GUI).
1. Download the latest version of the EVM GUI installer from the
Tools and Software
folder of the
TLV2553EVM-PDK, and run the GUI installer to install the EVM GUI software on your computer.
2. Accept the license agreements as shown in
and follow the onscreen instructions to complete
the installation.
Figure 4. TLV2553 Software Installation Prompts
