Texas Instruments TLC6C5816-Q1EVM, Руководство пользователя, Страница: 4 / 17

LED Supply
IC Supply
Put shunt on J28
to connect
USB2ANY 3.3 V
to IC Supply
USB2ANY
Connector
Put shunt on J32
power U1 in cascading
device mode
Put shunt on J33 and remove
shunt on J31 to configure
EVM for single device mode
Put shunt on J31 and remove
shunt on J31 to configure
EVM for cascading device mode
USB2ANY
TLC6C5816EVM
DC Supply
5V
USB
Cable
V
SENSE
V
CC
GND
Put Shunt on J3 supply
V
CC
from USB2ANY
Test Setup and Results
www.ti.com
4 SLVUB43 – September 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
TLC6C5816-Q1EVM User's Guide
2 Test Setup and Results
2.1 Hardware Setup
Figure 2 shows the hardware setup of the TLC6C5816EVM.
• Connect a 12-V power supply between TP31 (V
SENSE
) and TP29 (GND), or connect a 5-V power supply
to J27 via a Micro-USB cable.
• Put a shunt on J28 to use the USB2ANY 3.3-V supply to power V
CC
.
• Connect USB2ANY to the computer.
• Connect the USB2ANY board to the TLC6C5816EVM.
Figure 2. TLC6C5816EVM Hardware Setup
Figure 3 shows the key connectors to launch the TLC6C5816EVM.
Figure 3. TLC6C5816EVM Key Connectors