9.
Apply hot glue around the circumference of the transducer
10.
and continue covering transducer until it is completely covered in hotglue
11.
Use air to gently cool glue.
Страница 1: ...3 Plastic test cell container 4 400 grit sandpaper 5 Alcohol 6 Hot glue gun 7 Ultrasonic transducers w attached wires 8 Spray duster air gun Assembly Steps 1 Roughen 1cm square area on lower side of plastic container with sandpaper 2 Degrease with alcohol 3 Dry area with air gun 4 Apply CYA glue to 1cm square area ...
Страница 2: ... to side of container 6 While applying gentle pressure to transducer to hold it in place apply CYA Accelerator to transducer 7 Wait approximately 15 sec for glue to cure Blow off excess Accelerator 8 Apply alcohol to clean area Dry area with air gun ...
Страница 3: ...9 Apply hot glue around the circumference of the transducer 10 and continue covering transducer until it is completely covered in hotglue 11 Use air to gently cool glue ...
