Texas Instruments SimpleLink CC3100MOD, Руководство пользователя

Страница: 15 / 23

www.ti.com
Connecting to the PC Using EMUBOOST
15 SWRU396B – December 2014 – Revised May 2018
Submit Documentation Feedback
Copyright © 2014–2018, Texas Instruments Incorporated
CC3100MOD SimpleLink™ Wi-Fi® Network Processor Module BoosterPack
Hardware
Figure 15. The CC3100BOOST Connected to the EMUBOOST
CAUTION
Align the pin-1 of the boards together using the triangle marking on the PCB.
An incorrect connection can destroy the boards permanently.
Ensure that none of the header pins are bent before connecting the two boards.
3.3 Jumper Settings on the CC3100MODBOOST
Table 8 specifies the jumpers to be installed on the CC3100MODBOOST before pairing with the
EMUBOOST board.
Table 8. CC3100MODBOOST Jumper Settings
No. Jumper Settings Notes
1 J8 (1-2)
Power the BoosterPack from the EMU BOOST. Place the jumper near the edge of the
PCB.
3 J6 (short) No current measurement
4 J5 (short) OOB demo jumper
3.4 Jumper Settings on the EMUBOOST
Table 9 specifies the jumpers to be installed while pairing with the FTDI board.
Table 9. EMUBOOST Jumper Settings
No. Jumper Settings Notes
1 J4 (short) Provide 3.3 V to the BoosterPack
2 J22 (short) Provide 5.0 V to the BoosterPack
3 J3 (1-2) Route the NWP logs to the dual port