4.4 Capturing Waveforms
After you have a good ADC capture, go to the "Waveforms" tab to capture some waveforms. In the "Waveforms"
tab, click the "Start" button to start capturing waveforms. The GUI displays the Delta ToF, Absolute ToF, and
Volume Flow Rate waveforms (see
). Real time statistics are also available below each waveform. A
typical standard deviation value of Delta ToF can be seen in the red box shown in
Figure 4-10. Capturing Waveforms
The frequency of measurement updates can be increased by reducing the "UPS0 to UPS1 Gap" in the
"Configuration" tab.
After capturing waveforms for some time, you can save them to a file using the "Save Waveforms" button. The
"Lock All" button stops updates, and the "Reset Graphs" button erases all previously captured data.
USS GUI
14
Water Flow Meter
SLAU810B – SEPTEMBER 2019 – REVISED SEPTEMBER 2020
Copyright © 2020 Texas Instruments Incorporated