LOAD
INPUT
SUPPLY
(+)
(-)
(+)
(-)
DMM
(+)
(-)
DMM
Setup
2
SNVU583 – February 2018
Copyright © 2018, Texas Instruments Incorporated
LMR33630xRNXEVM User’s Guide
1
Setup
This section describes the test points and connectors on the EVM and how to properly connect, set up
and use the LMR33630xEVM. Either the banana jacks and test points on the top of the board can be used
for connections, or the card edge connector can be used. See
for the top of board connections,
and
and
for the card edge connections. The following lists the functions of the
connections:
•
VIN -
Input supply to EVM. Connect to a suitable input supply. See the
for input
supply requirements.
•
GND -
System ground
•
VOUT -
Output of EVM. Connect to desired load.
•
VOS -
Output voltage sense connection.
•
VIS -
Input voltage sense connection.
•
GNDS -
Ground sense point for analog measurements.
Figure 1. EVM Board Connections
