Texas Instruments LM63635DNEVM, Руководство пользователя, Страница: 5 / 16

1.2 Test Points
• VINEMI - Input supply to EVM. Connect to a suitable input supply.
• GND - System power ground.
• VOUT - Power output of EVM. Connect to desired load.
• VOS - Output voltage sense connection. Connect to DMM.
• VINS - Input voltage sense connection. Connect to DMM.
• GNDS - Ground sense point for analog measurements. Connect to DMM.
• EN - Connected to the EN input of the device.
• RESET - Connected to the RESET pin of the IC. It is used as a flag output. The reset function can be
monitored at this test point.
• SYNC/MODE - Connected to the SYNC/MODE pin of the IC.
• VCC - Connected to the VCC output of the device. Can be used for logic level pullups, if needed.
• OPEN PADS - Connections for frequency response analyzer (on bottom of board) to take Bode plots. See
Figure 1-4 for details of connections.
B
Signal
Injection
^ _
/ v‰µš š}
network analyzer
^ _
/ v‰µš š}
network analyzer
A
Figure 1-4. FRA Setup
www.ti.com Setup
SNVU767 – MARCH 2022
Submit Document Feedback
LM63635DNEVM EVM User’s Guide 5
Copyright © 2022 Texas Instruments Incorporated