Copyright © 2017, Texas Instruments Incorporated
Board Setup Examples
15
SLAU711 – March 2017
Copyright © 2017, Texas Instruments Incorporated
HSDC Pro With Xilinx
®
KCU105
7.2
ADC12J4000EVM With KCU105 Board Setup Example
The following section provides an example testing the ADC12J4000EVM in bypass mode using a KCU105
development platform.
NOTE:
There is a jumper "KC705 JTAG" on the ADC12J4000EVM that will prevent the firmware
from downloading if it is not shunted. By default, the board will have this jumper OPEN. The
jumper is
required
to be shunted in order for this integration to work. The jumper is located
on the top of the board near the FMC connector.
Make sure the instructions in
are completed before testing the EVM.
shows a setup
between the ADC12J4000EVM and KCU105.
Figure 12. ADC12J4000EVM Setup With KCU105