Overview
www.ti.com
1
Overview
The
INA193
is a current-shunt monitor with voltage output. The INA193EVM consists of one PCB. The
EVM consists of the INA193 device, screw-terminals, and test points for external hardware connections.
1.1
Kit Contents
Table 1
summarizes the contents of the INA193EVM kit. Contact the
Texas Instruments Product
Information Center
nearest you if any component is missing. Also, check the
INA193 product folder
on the
TI web site at www.ti.com for any further information regarding this product.
Table 1. INA193EVM Kit Contents
Item
Quantity
INA193 test board
1
1.2
Related Documentation from Texas Instruments
The following document provides information regarding Texas Instruments' integrated circuits used in the
assembly of the INA193EVM. This user's guide is available from the TI web site under literature number
SBOU147. Any letter appended to the literature number corresponds to the document revision that is
current at the time of the writing of this document. Newer revisions may be available from the
TI web site
,
or call the Texas Instruments' Literature Response Center at (800) 477-8924 or the Product Information
Center at (972) 644-5580. When ordering, identify the document by both title and literature number.
Table 2. Related Documentation
Document
Literature Number
INA19x product data sheet
SBOS307
2
Quick Start Setup and Use
Follow these steps to set up and use the INA193EVM:
1. Connect an external dc supply voltage (between 2.7 V and 18 V) to the V+ pin referenced to the GND
pin of the J1 terminal block.
2. Connect the desired input to the J2 terminal block. This desired input is either a external shunt resistor
or a differential voltage source with a common-mode voltage of –16 V to +80 V referenced to the GND
pin.
2
INA193EVM User's Guide
SBOU147 – August 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated
