1 Introduction
Figure 1-1. F280039C controlCARD
Each controlCARD comes with a Hardware Developer’s Kit, which is a full set of files necessary to evaluate and
develop with a C2000 device. These files include:
• Schematics – Designed in Altium
• Bill of Materials (BOM)
• Layout PCB files - Designed in Altium
• Gerber files
The Hardware Developer's Kit for the controlCARD can be found in the C2000Ware at the following location:
• <install directory>\c2000\C2000Ware_x_xx_xx_xx\boards\controlCARDs\TMDSCNCD280039C\Rx_x
Note
This kit is designed to explore the functionality of the F28003x microcontrollers. The controlCARD
can be treated as a good reference design; it is not intended to be a complete customer design.
Full compliance to safety, EMI/EMC, and other regulations are left to the designer of the customer’s
system.
2 Hardware Quick Setup Guide
The controlCARD can be completely powered and operated from the USB-C connector. In this stand-alone
mode the on-board isolated power supply will provide power to the F280039C device; no additional hardware
is required. Optionally, an external 5-V supply can be provided to power the F280039C device. For a detailed
explanation of the hardware configuration, see
WARNING
When the controlCARD is used in a high-voltage setup, it is the user’s responsibility to confirm that
the voltages and isolation requirements are identified and understood prior to energizing the board
or simulation. When energized, the controlCARD or components connected to the controlCARD
should not be touched. Furthermore, the capacitor C7:A should be removed to minimize the
possibility of leakage current flowing across the isolation barrier of the controlCARD.
Introduction
2
TMS320F280039C controlCARD Information Guide
SPRUIZ4B – MAY 2021 – REVISED JUNE 2022
Copyright © 2022 Texas Instruments Incorporated
