Texas Instruments DS90UB954-Q1EVM, Руководство пользователя, Страница: 13 / 67

Table 4-12. LEDs
Reference LED Color LED Name Description
D3 Red VDDIO Illuminates on VDDIO Power
D4 Red VDD5V Illuminates on +5V
D5 Red VDD_EXT Illuminates if 12V Power is applied to DC-IN J24
D6 Orange VPOC_RX1 Illuminates if VPOC_RX1 is ON
D7 Orange VPOC_RX0 Illuminates if VPOC_RX0 is ON
D8 Orange PASS Illuminates if PASS pin is HIGH
D9 Green LOCK Illuminates if LOCK pin is HIGH
D10 Green GPIO6 Illuminates if GPIO6 is HIGH
D11 Green GPIO5 Illuminates if GPIO5 is HIGH
D12 Green GPIO4 Illuminates if GPIO4 is HIGH
D13 Green GPIO3/INTB Illuminates if GPIO3 is HIGH, or GPIO3 disabled (pulled-up)
D14 Green GPIO2 Illuminates if GPIO2 is HIGH
D15 Green GPIO1 Illuminates if GPIO1 is HIGH
D16 Green GPIO0 Illuminates if GPIO0 is HIGH
5 Enable and Reset
The DS90UB954-Q1 is enabled and reset by controlling the PDB input level. PDB has an internal pull down, and
should remain low until all supplies are stable. There are three device enable and reset/power-down options for
the EVM.
• RC timing option: The RC delay created with C123 and R131 connected to the PDB pin is the default option
for delaying PDB on the EVM. This is used for simplicity of debugging and using the device. TI recommends
using a GPIO signal from a host process or to drive PDB after all rails have settled in customer designs.
• External control option: A momentary push-button switch, SW1, is available for manually driving the PDB
signal low while the button is held.
• Software control option: The PDB pin is also made available in the J24 and J26 CSI-2 output connectors,
allowing a host processor to control the PDB pin.
6 Use with DS90UB936-Q1
The DS90UB954-Q1EVM may also be used to evaluate the DS90UB936-Q1. The only modification required is
to swap the DS90UB954-Q1 with the DS90UB936-Q1.
www.ti.com Enable and Reset
SNLU223C – AUGUST 2017 – REVISED NOVEMBER 2022
Submit Document Feedback
DS90UB954-Q1EVM Deserializer User's Guide 13
Copyright © 2022 Texas Instruments Incorporated