Setup
7
SNLU213A – October 2016 – Revised September 2019
Copyright © 2016–2019, Texas Instruments Incorporated
DS280MB810EVM User’s Guide
Figure 4. DS280MB810EVM Default Configuration.
NOTE:
The jumper on J211 (if present) is connected only to pin 12, which is the pin in the white
box in
(the top right pin).
6. Connect a PC to DS280MB810EVM with a USB-to-Mini cable via J27.
7. Open SigCon Architect, and navigate to the “Configuration” page of DS280MB810 via the “Selection”
column. Choose “Slave Address” “0x30” from the drop down menu. Verify the “USB2ANY Details”
specify “USB2ANY 0," and click “Apply." Successful connection is indicated by the green
“CONNECTED” indicator on the bottom of the application, as seen below in
. Once connection
is successfully established, users can read and write various settings to the device in real-time, as
described in the following steps.