Table 4-2. Description of user selectable settings on DRV8317HEVM (H variant defaults in bold)
(continued)
Id.
Setting Name
Description
Position
Function
B
SLEW select
(DRV8317H only) Use J9
jumper to select desired
slew rate settings. DNP
jumper if DRV8317H is not
used.
J9 = Bottom
25 V/us
J9 = Middle
50 V/us
J9 = No Jumper
125 V/us
J9 = Top
200 V/us
C
MODE select
(DRV8317H only) Use J10
jumper to select desired
PWM mode. DNP jumper
if DRV8317H is not used.
J10 = Bottom
6x PWM mode
J10 = Middle
6x direct PWM mode
J10 = No Jumper
3x PWM mode
J10 = Top
3x direct PWM mode
D
Power LaunchPad from
buck
0-ohm R13 resistor on
bottom of board used
to supply power from
buck to LaunchPad. DNP
if powering LaunchPad
externally. See
on MCU Power
on
MCU power options
E
Supply 5 V from
LaunchPad
0-ohm R36 resistor on
bottom of the board
Supplies 5 V from the
F280049C LaunchPad
boost converter.
R36 is populated
Supply 5 V from
LaunchPad
R36 is DNP
Supply 5 V externally (if
desired) from the+5V test
point
F
Supply 3.3 V from buck
0-ohm R7 resistor
connects buck 3.3 V
voltage to supply main 3.3
V.
R7 is populated
Connects buck output to
supply 3.3 V rail
R7 is DNP
Supply 3.3 V externally
from the 3V3 test point
G
VIN_AVDD select
Use J1 to supply
VIN_AVDD voltage from
either VM or 5 V.
J1 = Left
VIN_AVDD supplied from
VM
J1 = Right
VIN_AVDD supplied from
5 V
H
HALL_EXT select
Use J2 to supply Hall
power externally or from
3.3 V
J2 = Left
Hall power supplied
externally from the HALL
PWR test point
J2 = Right
Hall power supplied
from 3V3
I
SPI variant connections
Populate specific resistors
to properly use the
Hardware or SPI variant
SPI variant: Populate R9,
R10, R11, and R12
J
VREF connection
0-ohm R54 resistor
supplies CSA REF from
on-board VREF
R54 is populated
CSA REF is supplied
from on-board VREF
voltage
R54 is not populated
CSA REF needs to
be supplied externally
through VREF test pin
Hardware and Software Overview
SLVUCL3 – DECEMBER 2022
DRV8317HEVM User's Guide
9
Copyright © 2022 Texas Instruments Incorporated