Out-of-the-Box Quick-Start Guide
10
SLOU476 – August 2017
Copyright © 2017, Texas Instruments Incorporated
DRV10987 Evaluation Module User's Guide
5
Out-of-the-Box Quick-Start Guide
This section assumes that the user has already downloaded the DRV10987 application GUI as mentioned
in
.
Perform the following procedure to confirm proper operation of the EVM kit:
Step 1.
Do not connect the motor phases and ensure that jumper J2 is set to
Analog
.
Step 2.
Set the speed input to 0 by rotating the potentiometer R2 fully counterclockwise.
Step 3.
Connect the motor phases of the user motor to connector P1. Phase sequence is not
important as it only determines the direction of rotation.
Step 4.
Connect the USB2ANY board to the computer using the supplied USB cable.
Step 5.
Connect the 10-pin ribbon cable header to J4 on the USB2ANY board and J3 on the
DRV10987 EVMs.
Step 6.
Connect a power supply to VCC (pin1) and GND (pin 5) of connector P1.
WARNING
Caution Hot surface. Contact may cause burns. Do not touch.
Step 7.
Power on the EVM VCC by applying 12 V to 24 V depending on the application..
CAUTION
With VCC, never exceed 28 V on the DRV10987 EVMs during motor operation.
Step 8.
Launch the DRV109XXEVM.exe application on the computer (see
Step 9.
Select the appropriate device configuration as shown in
.
Step 10.
Click the
OK
button.
Figure 8. Initial GUI Screen
•
If no hardware is connected, or if a hardware connection problem occurs, the GUI
